POWER OUTPUT

100 watts into an 8 ohm load is the minimum sine wave continuous average power output. The output RMS voltage is 28.3V across 8 ohms.

160 watts into a 4 ohm load is the minimum sine

wave continuous average power output. The output

RMS voltage is 25.3V across 4 ohms.

OUTPUT LOAD IMPEDANCE

8 and 4 ohms

RATED POWER BAND

20Hz to 20kHz

TOTAL HARMONIC DISTORTION

0.005% max harmonic distortion at any power level from 250 milliwatts to rated power, 20Hz to 20kHz

DYNAMIC HEADROOM

1.4dB

FREQUENCY RESPONSE

+0, -0.5dB from 20Hz to 20kHz

+0, -3dB from 10Hz to 100kHz

PREAMPLIFIER MAIN OUTPUT

1V for rated input (8V maximum)

SENSITIVITY (FOR RATED OUTPUT)

High level: 250mV unbalanced,

500mV Balanced;

Phono: 2.5mV; Power Amp In, 1V

SIGNAL-TO-NOISE RATIO (A-Weighted) High Level: 97dB below rated output Phono: 90dB below 10mV input

Power Amplifier: 110 below rated output

INTERMODULATION DISTORTION

0.005% max, if the instantaneous peak power output is rated power or less per channel with both channels operating for any combination of frequencies from 20Hz to 20kHz

WIDE BAND DAMPING FACTOR

200 at 8 ohms; 100 at 4 ohms

INPUT IMPEDANCE

High Level: 20K ohms; Phono: 47K ohms: 65pF; Power Amp In: 10K ohms

MAXIMUM INPUT SIGNAL

High Level: 8V; Phono: 90mV; Power Amplifier In: 8V

MAIN OUTPUT IMPEDANCE

50 ohms

POWER GUARD

Less than 2% THD with up to

16dB overdrive at 1000Hz

VOLTAGE GAIN

High Level to Tape Output: 0dB High Level to Main Output: 12dB Phono to Main Output:  52dB

POWER REQUIREMENTS

100/110 Volts, 50/60Hz at 3.6 amps

120 Volts, 50/60Hz at 3.2 amps

220/230/240 Volts, 50/60Hz at 1.8 amps

OVERALL DIMENSIONS (HxWxD)

7-5/8" (19.4cm) x 17-1/2" (44.5cm) x 22" (55.9cm)

including front panel and knobs.